User's Manual
Table Of Contents
- Copyrights
- Contact Us
- Document History
- FCC Information
- About LXN 500
- Overview
- Operation and Configuration
- Getting Started
- Powering On
- Powering Off
- What is Required for Configuration
- Connecting the LXN 500 to a Laptop
- Signing In
- Viewing System Notifications
- Signing Out
- Account Management
- Adding a Single Subscriber (UEs)
- Deactivating/Activating Subscriber
- Importing Subscribers From .csv File
- Deleting Subscriber
- Deleting All Subscribers
- UE Activity
- Statistics
- Setting the eNodeB
- Setting the System
- About LXN 500
- Configuring the DragonForce Server
- Configuring the WAVE 5000 Server
- Provisioning the Mobile Device (UE)
- Vehicle Installation
- Troubleshooting and Maintenance
- Technical Specifications
37
MN003563A01-B
Operation and Configuration
Send Feedback
4. Start the i Perf application on the mobile device.
5. Click the Start new test button and wait for the results to appear in the Result window.
Result: The test results is displayed in the Result window. The output contains a time-stamped
report of the amount of data transferred and the throughput measured.
6. Click Get Log to display the results of the last test or Clear Log to remove the lo
-t Ping the specified host until stopped.
•
To see statistics and continue - type Control-Break;
•
To stop - type Control-C.
-a Resolve addresses to hostnames
-n count Number of echo requests to send.
-l size Send buffer size.
-f Set Don't Fragment flag in packet (IPv4-only).
-i TTL Time To Live.
-v TOS Type Of Service (IPv4-only).
-r count Record route for count hops (IPv4-only).
-s count Timestamp for count hops (IPv4-only).
-j host-list Loose source route along host-list (IPv4-only).
-k host-list Strict source route along host-list (IPv4-only).
-w timeout Timeout in milliseconds to wait for each reply.
-R Trace round-trip path (IPv6-only).
-S srcaddr Source address to use (IPv6-only).
-4 Force using IPv4.
-6 Force using IPv6.
Command Line Option Description
Client/Server
-u, --udp Uses UDP instead of TCP.
-p, --port <Port> Connects with or expects data packets on this port (default: 5001).
-B, --bind <Interface> Permits the connection only via the specified interface (IP address or
interface name).
Server Specific
-s, --server Starts iPerf in server mode and waits for an iPerf client to contact it.