User's Manual
Table Of Contents
- Copyrights
- Contact Us
- Document History
- FCC Information
- About LXN 500
- Overview
- Operation and Configuration
- Getting Started
- Powering On
- Powering Off
- What is Required for Configuration
- Connecting the LXN 500 to a Laptop
- Signing In
- Viewing System Notifications
- Signing Out
- Account Management
- Adding a Single Subscriber (UEs)
- Deactivating/Activating Subscriber
- Importing Subscribers From .csv File
- Deleting Subscriber
- Deleting All Subscribers
- UE Activity
- Statistics
- Setting the eNodeB
- Setting the System
- About LXN 500
- Configuring the DragonForce Server
- Configuring the WAVE 5000 Server
- Provisioning the Mobile Device (UE)
- Vehicle Installation
- Troubleshooting and Maintenance
- Technical Specifications
35
MN003563A01-B
Operation and Configuration
Send Feedback
6. Click the Start new test button and wait for the results to appear in the Result window.
Result: The test results are displayed in the Result window. The output contains
a time-stamped
rep
ort of the amount of data transferred and the measured throughput.
7. Click Get Log to download a file with the latest test output or Clear Log to erase the log file created
for
the last test and clear the screen.
Figure 2-15
Communication Test Screen
Custom Test
The Custom Test is a network performance diagnostics between the LXN 500 and a mobile device. The
diagnostics is built out of a selection of tests configured by a command line. The custom test command
also supports pinging between LXN500 and mobile devices to test the connection.
Perform this procedure to test the LXN 500 communication.
Procedure:
1. Click Communication to test the LXN 500 communication.
Result: The Communication test screen is displayed.
2. Check Custom Test.
NOTE Before starting the Custom Test, make sure the mobile device is using iPerf2 client
application.