User's Manual
Table Of Contents
- Copyrights
- Contact Us
- Document History
- FCC Information
- About LXN 500
- Overview
- Operation and Configuration
- Getting Started
- Powering On
- Powering Off
- What is Required for Configuration
- Connecting the LXN 500 to a Laptop
- Signing In
- Viewing System Notifications
- Signing Out
- Account Management
- Adding a Single Subscriber (UEs)
- Deactivating/Activating Subscriber
- Importing Subscribers From .csv File
- Deleting Subscriber
- Deleting All Subscribers
- UE Activity
- Statistics
- Setting the eNodeB
- Setting the System
- About LXN 500
- Configuring the DragonForce Server
- Configuring the WAVE 5000 Server
- Provisioning the Mobile Device (UE)
- Vehicle Installation
- Troubleshooting and Maintenance
- Technical Specifications
25
MN003563A01-B
Operation and Configuration
Send Feedback
4. Click Add USIM to add another USIM to the LXN 500 or Clear to clear the current information
displaye
d in the fields.
Result: The newly added USIM is displayed in the table on the EPC tab.
Figure 2-6
USIM is Displayed in a Table on the EPC Tab Screen
5. Turn off your mobile device, install the USIM card and turn on the mobile device.
6. Refer to Provisioning the Mobile Device (UE) on page 45 to set your mobile device to operate with
the
LXN 500.
Deactivating/Activating Subscriber
The deactivation of a subscriber temporary deny service to that subscriber.
Perform this procedure to deactivate or activate a subscriber.
Procedure:
1. Sign in to the LXN 500 O&M Configuration site (See Signing In on page 20).
2. On the EPC screen, click the Off / On switch in the Active column of the relevant USIM.