User's Manual

23
MN003563A01-B
Operation and Configuration
Send Feedback
Passwords
The LXN 500 requires a sign in password to monitor, configure, administrate and service the LXN 500.
Passwords are based on three type of user roles and are not granted on personal bases.
Each user role is initially assigned with a default password that can only be changed by an administrator.
Table 2-2 shows the default password assigned to each user role.
Table 2-2 Default Password Assigned to Each User Role
Changing the User Password
Perform this procedure to change a password to a user role:
Procedure:
1. Log in as an Administrator.
2. Click on and select Change Password.
3. Select the User → enter the old password → enter a new password → reconfirm the new password
an
d click Change.
When changing a password note that a valid password must comply with the following rules:
• Use at least 15 characters in length password
• Use at least one uppercase character
• Use at least one lower-case character
• Use at least one numeric character
• Use at least one special character
• When changing a password, change at least 8 of the total number of characters.
IMPORTANT To avoid a security breach, it is recommended to change passwords upon signing in for
the first time. Change passwords frequently and establish a security policy that
determines a maximum password duration.
User Role Administrator Tech n i cia n Operator
User
admin tech user
Password
M0t0r0laAdm1n1! M0t0r0laT3ch12! MotorolaLXN5001!
IMPORTANT Changing a user role password does not effect other access permissions or
a
pplication passwords in the LXN 500.