User's Manual
Table Of Contents
- Copyrights
- Contact Us
- Document History
- FCC Information
- About LXN 500
- Overview
- Operation and Configuration
- Getting Started
- Powering On
- Powering Off
- What is Required for Configuration
- Connecting the LXN 500 to a Laptop
- Signing In
- Viewing System Notifications
- Signing Out
- Account Management
- Adding a Single Subscriber (UEs)
- Deactivating/Activating Subscriber
- Importing Subscribers From .csv File
- Deleting Subscriber
- Deleting All Subscribers
- UE Activity
- Statistics
- Setting the eNodeB
- Setting the System
- About LXN 500
- Configuring the DragonForce Server
- Configuring the WAVE 5000 Server
- Provisioning the Mobile Device (UE)
- Vehicle Installation
- Troubleshooting and Maintenance
- Technical Specifications
19
MN003563A01-B
Operation and Configuration
Send Feedback
What is Required for Configuration
Before starting to configure the LXN 500, obtain the following:
1. LXN 500 power supply unit.
2. Ethernet cable.
3. USIM cards for your mobile devices with information list that includes: identity, authentication,
operator code etc.
4. Operation information given by your authorities: frequency band, bandwidth, either downlink central
frequency in MHz or DL EARFCN, physical and logical cell ID and PLMN.
5. Laptop computer (With Google Chrome browser installed), mouse and keyboard.
Connecting the LXN 500 to a Laptop
The LXN 500 is configured by using Google Chrome to browse and access the LXN 500 Operation &
Management (O&M) site on the LXN 500.
IMPORTANT Before connecting the LXN 500 to a laptop, verify the laptop is disconnected from any wired
LAN connections and disable all wireless LAN connections.
Perform this procedure to connect the LXN 500 to a laptop.
Procedure:
1. Obtain the LXN 500 UID number from the information label on the LXN 500 (See Figure 2-1).
2. Set the parameters of the Local Area Connection of the laptop as described below.
For example: in Windows 10; in the search box on the taskbar, type
View network connections,
and then select View network connections → Properties → Networking tab → under This
connection uses the following items, select Internet Protocol Version 4 (TCP/IPv4) →
Properties → and set the following:
•
Use the following IP address: 10.98.66.2
•
IP address, Subnet musk: 255.255.0.0
•
Default gateway: 10.98.66.<UID>
3. Connect an Ethernet Cable between the LAN Port of a laptop and the MNG Port on the LXN 500.
4. Connect the Power Supply Unit to the LXN 500.
5. Power on the LXN 500 (See Powering On on page 18).
Figure 2-2
Connecting the LXN 500 to a Laptop
P
W
R
MNG Port
LAN Port
Ethernet Cable
Power Supply Unit