User's Manual
Table Of Contents
- Copyrights
- Contact Us
- Document History
- FCC Information
- About LXN 500
- Overview
- Operation and Configuration
- Getting Started
- Powering On
- Powering Off
- What is Required for Configuration
- Connecting the LXN 500 to a Laptop
- Signing In
- Viewing System Notifications
- Signing Out
- Account Management
- Adding a Single Subscriber (UEs)
- Deactivating/Activating Subscriber
- Importing Subscribers From .csv File
- Deleting Subscriber
- Deleting All Subscribers
- UE Activity
- Statistics
- Setting the eNodeB
- Setting the System
- About LXN 500
- Configuring the DragonForce Server
- Configuring the WAVE 5000 Server
- Provisioning the Mobile Device (UE)
- Vehicle Installation
- Troubleshooting and Maintenance
- Technical Specifications
MN003563A01-B
Operation and Configuration
18
Send Feedback
Powering On
1. Start the car engine.
2. Press and hold the Power button for four seconds and release when all LEDs begin to blink
gre
en.
Result: During boot-up, all LEDs blink green for about four minutes and then remain steady gre
en
indicatin
g a successful boot.
Powering Off
Starting Shutdown Sequence
1. Press and hold the Power button for four seconds.
Resul
t: all LEDs on the front panel blink orange, to indicate power down, and than turn off.
Forcing Power Off
1. Press and hold the Power button for 15 seconds.
Result: all LEDs on the front panel turn off.
IMPORTANT - When using the LXN 500 inside a vehicle, power on only after engine start.
- To enable a successful boot-up, remove all USB devices connected to the
LXN
5
00 before powering on.