User's Manual
Table Of Contents
- Copyrights
- Contact Us
- Document History
- FCC Information
- About LXN 500
- Overview
- Operation and Configuration
- Getting Started
- Powering On
- Powering Off
- What is Required for Configuration
- Connecting the LXN 500 to a Laptop
- Signing In
- Viewing System Notifications
- Signing Out
- Account Management
- Adding a Single Subscriber (UEs)
- Deactivating/Activating Subscriber
- Importing Subscribers From .csv File
- Deleting Subscriber
- Deleting All Subscribers
- UE Activity
- Statistics
- Setting the eNodeB
- Setting the System
- About LXN 500
- Configuring the DragonForce Server
- Configuring the WAVE 5000 Server
- Provisioning the Mobile Device (UE)
- Vehicle Installation
- Troubleshooting and Maintenance
- Technical Specifications
MN003563A01-B
Overview
16
Send Feedback
LXN 500 Back Panel Features
Figure 1-3 shows and Table 1-3 describes the features of the back panel of the LXN 500.
Figure 1-3
LXN 500 Back Panel Features
Table 1-3
LXN 500 Rear Panel Connectors
1
2
4
5
6
7
PWR
LTE1 LTE2
WIFI
GPS
NET
3
MNG
Protective Covers
Close covers when not in use.
Table 1-4
Back Panel Features
Connector Description
1NET
Network (NET) 1 GBit/s LAN port.
This port is used for connecting the LXN 500 to a Local Area Network (LAN) infrastructure
or an external application server. When maintenance is required, this port enables access
to the servers and eNodeB of the LXN 500.
2MNG
Management (MNG) 1 GBit/s LAN port.
This port is used for connecting an external laptop for configuration, management and
maintenance tasks.
3LTE2
LTE antenna connector.
4LTE1
LTE antenna connector.
5 PWR IN
9 to 33 VDC input power from car or backpack batteries
(Future option of the LXN 500)
.
IMPORTANT
Do not remove the power cable before shutting down the LXN 500.
Verify that the all LEDs on the front panel are off.
2GPS
GPS antenna connector.
3WiFi
Wireless LAN antenna connector.