Installation Manual

MN003109A01_aa
Motorcycle Radio Installation Installing the Emergency Switch Option 5-27
5.12 Installing the Emergency Switch Option
Use the two-conductor, green/black cable which has as one end terminated with two contacts (part
number 3080221P02) and which is supplied with this W688 Motorcycle Emergency Push Button.
Disconnect the emergency switch shorting plug from the accessory cable. Replace the shorting wire
of the shorting plug with the terminated end of the green/black emergency cable. Reconnect the plug
to the accessory cable.
5.13 Installing the External Alarm Relay Option
The motorcycle radio is offered with only one optional relay connection. If both horn and lights are
required, wire a second relay coil parallel to the first relay. Use the two-conductor green/black cable
which has one end terminated with two contacts (part number 3080221P02) and which is supplied
with this W116 Motorcycle Alarm Relay Option. Insert the contacts into positions 3 and 4 of the
emergency shorting plug of the accessory cable. Refer to Figure 5-26.
5.14 Installing the Headset Accessory
A six-position connector on the accessory cable has been made available for connecting a headset
accessory. Headset manufacturers should be consulted for compatibility with the motorcycle radio
prior to purchase and installation of the headset. To install, disconnect the headset shorting plug.
Remove the headset shorting wire from the headset shorting plug. Terminate the contacts provided
to the applicable wires of the headset cable. Insert the terminated wires into the headset shorting
plug per the contact positions illustrated in the typical headset schematic found in this manual.
Reconnect the terminated headset shorting plug to the accessory cable.
When upgrading from an APX mobile radio, the existing headset cable HLN6890 requires these two
pins to be swapped (see Figure 5-21). The other motorcycle headset cable with this pin change
already performed is called cable 3080010R04.
Table 5-1. Transceiver Installation Parts List
Item No. Description Item No. Description
1
Lock washer
10
Ground shield plane
2
Flat washer (8 used)
11
Top cover
3
Screw
12
Gasket
4
Screw
13
Hinge
5
Grommet
14
Enclosure mounts
6
Screw
15
Transceiver
7
Lock catch
16
Screw
8
Radio mounting plate
17
Trunnion
9
Bottom housing
18
External tooth lock washer (8 used)
Draft
mm
inateinate
xternal Alarm Re
xternal Alarm
offered with only one optiooffered with only on
ay coil parallel to the first ray coil parallel to the
d with two contacts (part nutwo contact
m Relay Option. InseRelay Option. Inse
rt the c
cessory cable. Refer to ry cable. Refe
Fig
essoryessory
ble hable ha
s been made av
s been made
onsulted for comnsulted for com
o install, disstall
shortinhor