Installation Manual

MN003109A01_aa

Motorcycle Radio Installation Installing Antenna Base, Cables and Multiplexer 5-17

13. Route the coaxial cable for the 700/800, VHF or UHF antenna(s) through the cable clamps

per Figure 5-11 for VHF hole, Figure 5-12 for 700/800 hole and Figure 5-13 for UHF hole.

14. After routing cable, allow enough of the cable to reach the radio’s antenna connector and cut

off any excess length of the cable.

15. Install the connector per Antenna Installation Manual.

Figure 5-10. Routing the GPS/Wi-Fi Cable

Be sure to observe the correct routing of the antenna cable. Failure to do so can damage the

cable.

C a u t i o n

Cable routes underneath

radio mounting plate and

connects to multiplexer

mounted underneath radio

on the radio mounting plate

Cable Clamps need to

be included and

routing to be through

cable clamps

GPS/Wi-Fi cables

connect to radio

directly

NOTE: Do not cut

the antenna cable

aft

Draft

raf

Dra

raf

raft

aft