Installation Manual

MN003109A01_aa
4-12 Options and Accessories Installation Motorola Branded SB9600 Siren Connection to APX 8500
Figure 4-12. Interfacing the Y-cable to the Motorola Branded SB9600 Siren and External Accessories
The Y-cable KT000247A01 is primarily designed to allow for simultaneous operation of the Motorola
Branded SB9600 siren and still retain duplicate access to all the MAP (J2) connector pins located on
the APX 8500 remote TIB. Use of emergency accessories, speakers, programming cables, VIPS,
etc are possible via the P3 connector of Y-cable KT000247A01. The 25pin connector P2 does not
contain every signal from the legacy DB25 port, called J600 on the APX 7500. Therefore, some
legacy functionality (i.e. A+) is reduced with the APX 8500 remote mount configuration compared to
the APX 7500 remote mount configuration.
NOTE: Only USB 1.5 meter data cable HKN6163_ is approved for use in series with the Y-cable
KT000247A01 at connector P3. USB 4 meter data cable HKN6172_ is not approved for use
in series with the Y-cable at connector P3.
Siren Cable
Draft
o the Motoo the Mot
01 is primarily designed t
01 is primarily desig
d still retaind still
duplicate acceduplicat
se of se of
emergency accessoremergency acc
nector of Y-cablf Y-cabl
e KT00024e K
cy DB25 port, calleDB25 port, calle
d J600 d
ed with the APd with the A
X 8500 remoX 850
on.
N6163_ is aN6163_ is
pproved for use
pproved for u
meter data cable HKN6
meter data cable HK