Installation Manual

MN003109A01_aa

Introduction Motorcycle Configurations 1-11

1.2.3 Multi Control Head

The multi control head option allows separate, remotely operated control heads to operate and

control the radio. For example, a fire truck could have a control head located in the cab and on the

rear of the truck so that the radio could be operated from outside the vehicle.

1.3 Motorcycle Configurations

NOTE: The motorcycle configurations are not applicable for O9 control heads.

See Chapter 5: Motorcycle Radio Installation for further information.

1.4 Base/Control Stations

NOTE: The base/control station option is not applicable for O9 control heads.

If mobile radio equipment is installed at a fixed location and operated as a control station or as a

fixed unit, the antenna installation must comply with the following requirements in order to ensure

optimal performance and compliance with the RF energy exposure limits in the standards and

guidelines listed in the Safety Manual (refer to related publications):

• The antenna should be mounted outside the building on the roof or a tower if at all possible.

• As with all fixed site antenna installations, it is the responsibility of the licensee to manage the

site in accordance with applicable regulatory requirements and may require additional

compliance actions such as site survey measurements, signage, and site access restrictions in

order to ensure that exposure limits are not exceeded.

1.5 Tools Required for APX Mobile Installations

Tool Part Number

10 mm wrench –

5 mm Allen wrench –

Regular slot screwdriver of Phillips #2 –

Pin removal tool 6680163F01

s #22

aft

–

aft

––

aft

raft

Part NPart N

Draf

ountedounte

tenna insttenna inst

allaall

with applicable reguwith applicable re

ns such as site survey m

ns such as site surv

at exposure limits are not at exposure limits

r APAP

X Mobile InstaX Mobile

raf

aft