Installation Manual

MN003109A01_aa

4-4 Options and Accessories Installation Remote-Mount Accessory Installation

Figure 4-4. Gunlock Switch Redundancy Diagram

NOTE: Refer to section 4.3.1 for information related to wiring and activation of VIPOUTs

The Y-cable KT000247A01 is primarily designed to allow for simultaneous operation of the Motorola

Branded SB9600 siren and still retain duplicate access to all the MAP (J2) connector pins located on

the APX 8500 remote TIB. Use of emergency accessories, speakers, programming cables, VIPS,

etc are possible via the P3 connector of Y-cable KT000247A01. The 26pin connector P2 does not

contain every signal from the legacy DB25 port, called J600 on the APX 7500. Therefore, some

legacy functionality (i.e. A+) is reduced with the APX 8500 remote mount configuration compared to

the APX 7500 remote mount configuration.

VIP OUT

GND

Gunlock

Redundancy

Wiring

Car Battery

A+ into Transceiver

VIP OUT pin from

either J2 (Transceiver)

or J400 (control head)

Momentary or

time-out bypass

manual switch

Relay and Diode for

Activation of Gunlock

aft

witch Redundancy Diagram

witch Redundancy Diagra

d to wiring andto wiring

w for s

for

Draf

Dra