Installation Manual

MN003109A01_aa

2-26 Standard Configurations Radio Mounting

2.2.2.3 Cable Installation

Route the cables where they are protected from pinching, sharp edges or crushing. Use grommets in

any holes where the cable passes through metal panels. Figure 2-15 shows how the cables and

components are connected. It is not recommended to route cabling or wiring inside the wheel wells

of a vehicle.

2.2.2.4 Setting the Initial Control Head ID

The Front Panel Programming (FPP) mode allows you to define which control head in a Multi Control

Head system becomes control head number 1-4.

Set the control head ID number for each attached head the first time Multi Control Head is used.

1. Press the power button to power off the radio.

2. Press and hold left-most menu and the orange button on the control head simultaneously.

Figure 2-26. APX Mobile O5 Control Head Front View

3. Press the power button to power on the control head. The head will power on into FPP mode

and display the current control head ID number:

Figure 2-27. Radio Display with Current Control Head ID

4. Turn the Mode knob to change the control head’s ID number.

Figure 2-28. APX Mobile O5 Control Head Front View – Mode Knob

5. Repeat steps 1 to 4 above to set the ID of the remaining control heads.

NOTE: In Multiple Control Head (MCH) installations, the yellow ignition sense wire must be

connected to the head assigned ID # 1.

Left-most

Menu Button

Power Button

Emergency

Button

CH ID#

Mode Knob

Draft

X Mobile O5Mob

Control HeadContro

er on the control head. Thethe control h

ad ID number:d ID number:

Left-most Left-most

Menu ButtonMenu Button

aft