User's Guide

2
Press or to Contacts. Press to
select.
3
Press or to Manual Dial. Press to
select.
4
Press or to Phone Number. Press
to select.
The display shows Number: and a blinking cursor.
5
Enter the telephone number, and press
to
proceed.
The display shows Access Code: and a blinking
cursor if the access code was not preconfigured.
6
Enter the access code, and press to proceed.
The access or deaccess code cannot be more than
10 characters.
The green LED lights up. The display shows the
Phone Call
icon, subscriber alias, and call status.
If the call is successful:
• The DTMF Tone sounds.
• You hear the call waiting tone of the telephone
user.
•
The display shows subscriber alias and the
Phone Call icon.
If the call is unsuccessful:
• A tone sounds.
• The display shows Phone Call Failed and
then, Access Code:.
• Your radio returns to the screen you were on
before initiating the call if the access code has
been preconfigured in the Contacts list.
7
Press to end the call.
8 Do one of the following:
• If the deaccess code was not preconfigured,
enter the deaccess code when the display shows
De
-Access Code:, and press
to proceed.
The radio returns to the previous screen.
English
90 Send Feedback