User's Guide

press the button to proceed. The DTMF
tone sounds and the radio returns to the previous
screen.
• Press One Touch Access button. The DTMF
tone sounds. If the entry for the One Touch
Access button is empty, a negative indicator tone
sounds.
5
Press to end the call.
If deaccess code was not preconfigured in the
Contacts list, the display shows De-Access Code:.
Enter the deaccess code and press the button
to proceed.
The DTMF tone sounds and the display shows
Ending Phone Call.
If the end-call-setup is successful, a tone sounds
and the display shows Call Ended.
If the end-call-setup is unsuccessful, your radio
returns to the Phone Call screen.
When you press PTT button while in the Phone
Contacts screen, a tone sounds and the display
shows Press OK to Place Call.
When the telephone user ends the call, a tone
sounds and the display shows Phone Call Ended.
If the call ends while you are entering the extra digits
requested by the Phone Call, your radio returns to
the screen you were on prior to initiating the call.
NOTICE:
During channel access, press to
dismiss the call attempt and a tone sounds.
During the call, when you press One Touch
Access button with the deaccess code
preconfigured or enter the deaccess code as
the input for extra digits, your radio attempts
to end the call.
During channel access and access/deaccess
code or extra digits transmission, you radio
responds to On/Offbutton, Volume On/Off
Volume Knob , and Channel Up/Down
Channel Rocker only. A tone sounds for
every invalid input.
English
84 Send Feedback