User's Guide

If the call fails to end, the radio returns to the Phone
Call screen. Repeat the last two steps or wait for the
telephone user to end the call.
Making Phone Calls with the
Programmable Button
Follow the procedure to make Phone Calls with the
programmable button.
1 Press the programmed Phone button to enter into
the Phone Entry list.
2
Press or to the required alias or ID.
Press to select.
If the access code was not preconfigured in the
Contacts list, the display shows Access Code:.
Enter the access code and press the button to
proceed.
The green LED lights up. The display shows Phone
Call
icon, subscriber alias or ID, and call status.
If the call-setup is successful:
• The DTMF tone sounds.
•
You hear the call waiting tone of the telephone
user.
•
The display shows Phone Call icon, subscriber
alias or ID, Phone Call, and call status.
If call-setup is unsuccessful:
• A tone sounds.
• The display shows Phone Call Failed.
• Your radio returns to the Access Code input
screen. If the access code was preconfigured in
the Contacts list, the radio returns to the screen
you were on prior to initiating the call.
3 Press the PTT button to talk. Release the PTT
button to listen.
The RSSI icon disappears during
transmission.
4 To enter extra digits, if requested by the Phone Call.
Do one of the following:
• Press any keypad key to begin the input of the
extra digits. The display shows Extra Digits:
and a blinking cursor. Enter the extra digits and
English
Send Feedback 83