User's Guide

3 Press and hold the PTT button to talk longer than the
programmed duration.
Initiating an Emergency Alert
NOTICE:
If your radio is programmed for "Silent" or "Silent
with Voice", it will not provide any audio or visual
indications that it is sending an Emergency Alert. If
programmed for "Silent", the silent operation
continues indefinitely until you press PTT or the
button configured for "Emergency Off". If
programmed for "Silent with Voice", the radio
automatically cancels silent operation when the site
controller broadcasts the Emergency Alert.
Press the orange Emergency button.
Upon transmitting the Emergency Alert to the site
controller, the radio display shows the Emergency
icon, the Group contact used for the Emergency
Alert, and TX Alarm.
Once the Emergency Alert is successfully sent and is being
broadcast for other radios to hear, a positive indicator tone
sounds and the radio displays Alarm Sent. If the
Emergency Alert is unsuccessful, a negative indicator tone
sounds and the radio displays Alarm Failed.
Exiting Emergency Mode
NOTICE:
If the Emergency call ends due to the expiration of
the Emergency Hang Time, but the emergency
condition is not over, press the Emergency button
again to restart the process.
If you initiate an Emergency Alert by pressing the
programmed Emergency button, your radio automatically
exits Emergency mode after receiving a response from the
Connect Plus system.
If you initiate an Emergency call by pressing the
programmed Emergency button, your radio will be
assigned a channel automatically when one becomes
available. Once your radio has transmitted a message
indicating the emergency, you cannot cancel your
Emergency call. However, if you pressed the button by
accident or the emergency no longer exists, you may wish
to say this over the assigned channel. When you release
the PTT button, the Emergency call is discontinued after
the Emergency Call Hang Time expires.
English
Send Feedback 267