User's Guide

Scan Talkback
If your radio scans into a call from the selectable group
scan list, and if the PTT button is pressed during the
scanned call, the operation of the radio depends on
whether Scan Talkback was enabled or disabled during
radio programming. Check with your dealer or system
administrator for more information.
Scan Talkback Disabled
The radio leaves the scanned call and attempts to
transmit on the contact for the currently selected
channel position. After the Call Hang Time on the
currently selected contact expires, the radio returns to
the home channel and starts the Scan Hang Time
Timer. The radio resumes group scan after its Scan
Hang Time Timer expires.
Scan Talkback Enabled
If the PTT button is pressed during the Group Hang
Time of the scanned call, the radio attempts to transmit
to the scanned group.
NOTICE:
If you scan into a call for a group that is not
assigned to a channel position in the currently
selected zone and you miss the Hang Time of the
call, switch to the proper zone and then select the
channel position of the group to talk back to that
group.
Editing Priority for a Talkgroup
The Priority Monitor feature allows the radio to
automatically receive transmission from the talkgroup with
higher priority when it is in another call. A tone sounds
when the radio switches to the call with higher priority.
There are two levels of priority for the talkgroups: P1 and
P2
. P1 has higher priority than P2.
NOTICE:
If Default Emergency Revert Group ID is configured
in MOTOTRBO Connect Plus Option Board CPS,
there are three levels of priority for talkgroups: P0,
P1, and P2. P0 is the permanent Emergency Revert
Group ID and the highest priority. Check with your
dealer or system administrator for more information.
1
Press to access the menu.
English
Send Feedback 249