User Manual

target alias. Once the timer expires, the radio
sounds an alert tone and the LED turns off.
If unsuccessful, the radio sounds a negative
indicator tone the display shows Rem. Monitor
Failed.
Scan
This feature allows your radio to monitor and join calls
for groups defined in a pre-programmed scan list.
When scan is enabled, the scan icon appears on the
status bar and the LED blinks yellow when idle.
Starting and Stopping Scan
Note:
This procedure turns the Scan feature On or
Off for all Connect Plus zones with the same
Network ID as your currently selected zone. It
is important to note that even when the Scan
feature is turned on via this procedure, scan
may still be disabled for some (or all) groups
on your scan list. See Editing the Scan List on
page 210 for more information.
You can start and stop scanning by pressing the
programmed Scan button OR follow the procedure
described next.
1
to access the menu.
2
or to Scan and press to select.
3
or to Turn On or Turn Off and press
to select.
•
The display shows Scan On if scan is enabled.
•
The Scan menu shows Turn Off if scan is
enabled.
•
The display shows Scan Off if scan is
disabled.
•
The Scan menu shows Turn On if scan is
disabled.
Responding to a Transmission During a Scan
During scanning, your radio stops on a group where
activity is detected. The radio continuously listens for
any member in the scan list when idle on the control
channel.
Advanced Features in Connect Plus Mode
208
English