User Manual
Table Of Contents
- Contact Us
- Copyrights
- Document History
- Contents
- List of Figures
- List of Tables
- About VML750 LTE Vehicular Subscriber Modem (VSM) Installation Guide
- VML750 Description
- VML750 Installation
- VML750 Troubleshooting Causes and Indicators
- VML750 Operation
- VLM750 Specifications
- LTE LMR Antennas Mounting Recommendations
Send Feedback
21
6802988C54-D
Chapter 2: VML750 Installation
Installing the LAN/Ethernet Cable
Perform this procedure to install the LAN/Ethernet cable.
Procedure:
1
Connect the LAN/Ethernet cable from the LAN connector on the VML750 LTE Vehicular
Subscriber Modem (VSM) Connector panel to your vehicle Mobile Data Terminal.
CAUTION: Do not use pliers or any other metallic tool for tightening. Hand- tighten
only. Fully tighten the LAN/Ethernet cable connector and verify it is fastened.
2
Follow the LAN/Ethernet cable 8 +/–2 inches (20 +/–5 cm) from where it attaches to the VML750
and secure it to the vehicle body.
Installing the Micro USB Cable
Perform this procedure if you are not installing the LAN/Ethernet cable.
Procedure:
1
Connect the Micro USB cable from the Micro USB connector on the VML750 LTE Vehicular
Subscriber Modem (VSM) Connector panel to your vehicle Mobile Data Terminal USB
connector.
CAUTION: Do not use pliers or any other metallic tool for tightening. Hands tighten
only. Fully tighten the Micro USB cable connector and verify it is fastened.
2
Follow the Micro USB cable 8 +/–2 inches (20 +/–5 cm) from where it attaches to the VML750
and secure it to the vehicle body.