User's Manual

Chapter 3 Configuring and Monitoring the
VML700
Introduction
The VML700 is basically a plug and play modem and will, most of the time, access the network without any
configuration.
Some service providers require special security configuration. Also, there are some basic configuration that may
be done after first time installation.
This chapter provides required security configuration procedures and other general configuration procedures that
may be done by your system administrator after the modem installation completion.
In addition, this chapter describes some basic VML700 operation indications that appear on your computer and
enable you to monitor your VML700 operation.
Prior to Configuration
1. Connect a LAN/Ethernet cable between the VML700 and your computer.
2. Turn the VML700 On.
3. Verify your computer in On and open your web browser.
4. In the web address field, enter the VML700 IP address (http://192.168.15.1) and press “Enter”.