User's Manual
Table Of Contents
- Patents
- Warranty
- Revision History
- Introduction
- Configurations
- Chapter Descriptions
- Notational Conventions
- Related Documents
- Service Information
- Safety
- FCC Interference
- WiMAX VSM Description
- Installation
- Configuring and Monitoring the VSM
- Troubleshooting
- Specifications
- Reference
2 - 10 WiMAX VSM Installation Guide
Antennas Mounting
Process 2-2 gives general instructions for mounting all types of antennas.
Special Antennas Installation Considerations
General Antenna Installation Safety Considerations
WiMAX Antennas
NOTE The WiMAX antennas must be installed on the vehicle’s roof. For best performance, the minimum distance between the
two WiMAX antennas should be 39.4” (1m).
WiFi Antenna
GPS Antenna
NOTE The GPS antenna must be installed on the vehicle’s roof. For best GPS performance, the minimum distance between
this antenna and other antennas should be at least 11.8” (30 cm).
8
Connect the GPS cable (see GPS Antenna Cable Installation on page 2-13)
9
Connect the LAN/Ethernet cable. (See LAN/Ethernet Cable Installation on page 2-14)
10
Place caps on unused connector(s). (See Cap Installation on page 2-14)
Process 2-1
Modem Installation Process (Continued)
Process 2-2
How to Mount the Antennas
1
Mount the antennas in accordance with the instructions provided with the each antenna kit and with the
Product Safety and RF Energy Exposure Booklet for Mobile Two-Way Radios Installed in Vehicles or as
Fixed Site Control Stations (6881095C99) enclosed with the product.
WARNING! The WiMAX and WiFi antennas must be installed in a location that will ensure a distance of at
least 8” (20cm) between them and any bystander.
CAUTION The WiFi Antenna must be installed on the vehicle’s trunk hood to ensure at least 40 dB isolation
between this antenna and the WiMAX antennas. Failure to comply may result system performance
degradation.