User's Manual

Installation 2 - 5
• When drilling a hole in the roof, take care not to snag the roof liner.
• To prevent rusting after drilling, remove all metal burrs and residue, and completely clean the area to ensure
the removal of all steel dust.
• Insert rubber grommets in all drilled holes to protect cables.
Tools and Equipment
• #2 Phillips screwdriver
• Electrical drill and drill bit set
• X-acto knife or equivalent
• Wire stripper
• Long nose pliers
• Small side cutters
• Crimping tool
• Wrench set, including 8 mm for tray to unit attachment
• 3 mm Allen wrench set for unit to tray attachment
• Soldering iron and solder
• Electrical tape