User's Manual

2 - 4 WiMAX VSM Installation Guide
Figure 2-2 gives the WiMAX VSM dimensions.
Figure 2-2 WiMAX VSM - Dimensions
Cables Routing
• Before running a wire or drilling a hole, inspect the vehicle and determine how and where you intend to
mount the antenna, modem, and the input/output device.
• Plan wire and cable routing to provide maximum protection from overheating, battery acid, moving parts and
sharp edges.
• Keep cables away from ignition circuits to reduce noise pickup in the radio equipment.
• Verify that the cables are of sufficient length. Do not connect two short lengths with a connector; doing so
results in signal loss. Refrain from loose excess in the cables, but leave enough slack to allow reconnection if
necessary.
• Do not run cables externally or underneath floor mats.
• Do not locate cables where the driver or passengers can kick them or where they can interfere with operation
of the driver’s foot pedals.
• When routing the cable, refrain from creating sharp bends or kinks.
Drilling Holes
• Where possible, use existing holes in the bulkhead, the trunk wall and the channels above or beneath the
doors. Run cables parallel to existing car cables if appropriate.
• If you must drill holes, verify not to damage other wiring, break lines or gas lines.
7.9”
(9.3 cm)
11.4”
(29 cm)
(20 cm)
3.66”