User's Manual

Chapter 3 Configuring and Monitoring the
VSM
Introduction
The WiMAX VSM is basically a plug and play modem and will, most of the time, access the network without any
configuration.
Some service providers require special security configuration.
This chapter provides required security configuration procedures and other general configuration procedures that
may be done by your system administrator after the modem installation completion.
In addition, this chapter describes some basic WiMAX VSM operation indications that appear on your computer
and enable you to monitor your WiMAX VSM operation.
Prior to Configuration
1. Connect a LAN/Ethernet cable between the VSM and your computer.
2. Turn the VSM On.
3. Verify your computer in On and open your web browser.
4. In the web address field, enter the VSM IP address (http://192.168.15.1) and press “Enter”.