User's Manual
Table Of Contents
- Patents
- Warranty
- Revision History
- Introduction
- Configurations
- Chapter Descriptions
- Notational Conventions
- Related Documents
- Service Information
- Safety
- FCC Interference
- WiMAX VSM Description
- Installation
- Configuring and Monitoring the VSM
- Troubleshooting
- Specifications
- Reference
Installation 2 - 13
WiMAX Antenna Cable Installation
NOTE The installation procedures for both WiMAX antenna cables are identical.
WiFi Antenna Cable Installation
GPS Antenna Cable Installation
NOTE The GPS antenna cable is part of the GPS antenna assembly.
5
Verify that the cables in the engine compartment do not obstruct any of the vehicle controls or touch hot or
moveable parts of the engine.
6
For ignition installation, perform the following steps:
a. Cut the green lead to the desired length.
b. Connect the green lead of the DC Power cable to ignition (+). Cable tie the wire every 4” (10 cm) along
its length, do not tie to existing vehicle systems.
c. Verify that the voltage is high with ignition on, during cranking and while vehicle is running. When ignition
is off, the voltage is low.
7
Connect the DC Power cable connector and the Ignition connector to POWER connector and IGN connector
on the Connectors panel. Do not use pliers or any other metallic tool for tightening. Hand tighten only!
Process 2-4
How to Install the DC Power and Ignition Cable (Continued)
Process 2-5
How to Install the WiMAX Antenna Cable
1
The WiMAX antennas are supplied with a 12 feet cable. Do not trim this cable after routing it. Form a
service loop to any cable excess length. Use plastic cable ties to secure the cable. The field team
should assemble the TNC connector (provided) after routing the RF cable.
2
Connect the RF cables from the antennas to ANT1/ANT2 connector on the Connectors panel (the order of
connection is not important). Do not use pliers or any other metallic tool for tightening. Hand tighten only!
Fully tighten the antenna cable connector.
Process 2-6
How to Install the WiFi Antenna Cable
1
When assembling, trim the RF cable as short as possible, so as to provide minimal loss and best
coverage.The field team should assemble the SMA connector (provided) after routing the RF cable.
2
Connect the RF cable from the antenna to WIFI1 connector on the Connectors panel. Do not use pliers or
any other metallic tool for tightening. Hand tighten only! Fully tighten the antenna cable connector.
Process 2-7
How to Install the GPS Antenna Cable
1
Connect the RF cable from the antenna to GPS connector on the Connectors panel. Do not use pliers or any
other metallic tool for tightening. Hand tighten only! Fully tighten the antenna cable connector.