User Manual

13
Wireless Remote Control Adapter
Status Indicator
The wireless remote control adapter has a green
light emitting diode (LED) to let you know what it is
doing. The blinking pattern will let the user know
when the car is ready to drive.
The status LED blink pattern will blink a pattern of
short (0.1 second) on-off blinks and then turn off
the LED for one second and then repeat the blink
pattern again.
When you first connect the wireless remote control
adapter, it will blink one time to indicate that it is
powered by the joystick controller.
Next the status indicator will blink two times to
indicate that it is trying to connect to a car.
The normal operation for driving a car is called the
connected state would be a three blink pattern. It
would be three 0.1 sec LED light flashes then no
flashes for one second and then it would repeat the
pattern.
The value below is the number of blinks in each
pattern.
Value State Description
1 Blink Standby Power saving - Not
controlling the RC
car
2 Blinks Discoverable or
Discovery
RC car or wireless
remote control
adapter is looking
for each other
3 Blinks Connected The wireless
remote control
adapter or joystick
controller is
controlling an RC
car