User's Guide

NOTICE: If you hang a fist microphone or telephone style handset into the clip or holder,
the call ends or the audio switches to a connected speaker. This call behavior depends
on the configuration of your service provider.
5.10
Multi Radio Control
NOTICE: This feature is a selling feature.
This feature allows the user to control two radios from a Control Head. The user can monitor one task
force and communicate with another task force simultaneously.
Radio 1 is the primary radio and Radio 2 is the secondary radio. Radio 1 and Radio 2 are connected
to each other, with Radio 1 directly connected to the control head.
5.10.1
Selecting Radios
The control head only controls one radio at a time.
When and where to use: Press the One-Touch Button to select the next available radio or perform the
following steps to select a radio via the menu.
Procedure:
1 From the home screen, press the
Menu key.
2 Select Radio Selection.
3 Select one of the following options:
• Radio 1
• Radio 2
The Radio Selection Tone sounds when a radio is selected from the one-touch button or the Radio
Selection menu.
NOTICE: Check with your service provider to enable the Radio Selection Tone feature.
5.11
OEM Control Head
NOTICE: This feature is a selling feature.
This feature allows you to connect an Original Equipment Manufacturer (OEM) or third-part Control
Head to the transceiver Rear Accessory Connector (RAC). The display of the OEM Control Head has
the same functionality and look as a Motorola Solutions Control Head.
The OEM Control Head can be used in one of the following modes:
Single Control Head mode
The OEM Control Head is the only control head connected to the transceiver.
Dual Control Head mode
The OEM Control Head is connected to the transceiver together with either a Remote Ethernet
Control Head (RECH) or a Telephone Style Control Head (TSCH).
68015000180-MG
Chapter
5:
Features
130