User Manual

Table Of Contents
NOTICE: When the Gateway Mode is enabled, you cannot make any call.
Standby Mode
Your radio enters Standby mode if there is another Gateway on the same DMO frequency. Gateway
icon flashes and no transmission is forwarded through the gateway. To exit Standby Mode you can:
Choose another DMO talkgroup
Wait untill the other gateway is out of coverage and is no longer present on that DMO talkgroup
Forwarding Group Calls
Your radio shows the source and destination talkgroup of the Group call.
Setting Monitor Options
Procedure:
1 From the home screen, press Optns.
2 Press Config and Select one of the following:
Off — Audio of the calls are not routed to the speakers of the gateway.
Receive Only — Audio of the calls are routed to the speakers of the gateway.
Emergency Calls in Gateway Mode
Press the EMERGENCY button to enter the TMO Emergency mode and start an Emergency Group call.
Check with your service provider if the Emergency Group call starts on a tactical or non-tactical
talkgroup. If the radio that is in the Gateway mode receives an Emergency Group call, it forwards it to
the respective TMO/DMO talkgroup that is currently switched to.
Encryption in Gateway Mode
While in the Gateway Mode, the radio supports Air Encryption and is able to transmit encrypted calls
among radios operating in TMO and DMO.
If SCK keys installed on the radio are invalid, the radio cannot function as a gateway and transmit calls.
Chapter 3: Modes
Send Feedback 65