User Manual

Table Of Contents

NOTICE: If the One-Touch Button feature is enabled, the One-Touch Dial is disabled. If no

feature is assigned to a button, your radio displays an Unassigned Button message.

Terminal Temporary Disable/Enable

Your radio is provided with a feature that allows your service provider to disable it temporarily in case it

is stolen. When your radio is disabled or is powered up in disabled state, it looks and acts like it is

turned off.

If your radio is found, your service provider can enable it again over the air. After your radio is enabled,

you may resume normal operation.

Terminal Permanent Disable

Your radio is provided with a feature that allows your service provider to disable it permanently in case

it is stolen or lost. When your radio is disabled permanently, it becomes inoperable. After a Permanent

Disable your service provider cannot enable your radio. It is recommended to Permanent Disable your

radio only when you do not expect to recover it. If it is recovered then a Permanent Disable radio can

be reactivated by returning it to Motorola.

NOTICE: This is a selling feature.

During the Call

During the call, label of the right SOFT key indicates the next possible change. Accessory default setup

is:

Table 11: During the Call

Soft Key Label Audio Setting

Spkr Audio goes to the main speaker (Speaker HIGH is displayed)

Erpce Audio goes to the earpiece (Speaker LOW is displayed)

Writing Text

Every time that you see text entry screen, refer to this section.