User Manual

• Migrate to... — Selects the required network form the list. To view the network ID press
MENU key then press Select.
• Auto — Your radio automatically attaches to the predefined network.
Location
See the GPS Location Service for more information.
Related Links
GPS Location Service on page 67
Viewing Your Position
Procedure:
1 From the home screen, press the MENU key.
2 Select Location → Position.
3 Scroll to view the results about the last time your location was calculated.
NOTICE: To refresh your position:
• Select Position — the radio refreshes its position automatically
• Press Refresh
Viewing Testpage
Procedure:
1 From the home screen, press the MENU key.
2 Select Location → Testpage.
3 Select one of the following:
• Position – displays detailed information on radio’s current position: time, N (latitude), E
(longitude), H (height), Sats Used (a number of tracked satellites), B (bearing), HS
(horizontal speed), LC (level of confidence).
• Power – displays detailed information on a particular satellite: PRN code, Status, Mode, C/N
(carrier-to-noise ratio).
• Version – displays detailed information on GPS version: SW (software version), HW
(hardware version), ASIC (application-specific integrated circuit), RC (release code).
Packet Data
The Packet Data (PD) Service allows you to transfer data in a TETRA system using the Internet
Protocol (IP).
NOTICE: To transfer data from a standard computer over the air, connect the computer via the
data cable PMKN4104 with your radio. Your service provider has to setup additional
applications on your computer.
If set up by your service provider it is possible to accelerate the transmission by using the Multi-Slot
Packet Data (MSPD) Service.
NOTICE: This is a selling feature.
Chapter 5: Main Menu
Send Feedback 111