User's Guide

The DTMF tone sounds with each keypad press,
and the radio returns to the previous screen.
4
Press to end the call.
If de-access code was not preconfigured in the
Contacts list, the display shows De-Access
Code:. Do one of the following.
•
Enter the de-access code and press
to
proceed. The radio returns to the previous
screen.
• Press the One Touch Access button. If the
entry for the One Touch Access button is
empty, a negative indicator tone sounds.
The DTMF tone sounds with each keypad press,
and the display shows Ending Phone Call.
If the end-call-setup is successful, a tone sounds
and the display shows Call Ended.
If the end-call-setup is unsuccessful, your radio
returns to the Phone Call screen. Repeat Step 4
on page 47 or wait for the telephone user to end
the call.
Note:
When the telephone user ends the call, a tone
sounds and the display shows Call Ended.
If the call ends while you are entering the extra
digits requested by the Phone Call, your radio
returns to the screen you were on prior to initiating
the call.
During channel access, press to dismiss the
call attempt. A tone sounds to indicate success.
During the call, if you press the One Touch
Access button with the deaccess code
preconfigured or enter the deaccess code as the
input for extra digits, your radio attempts to end
the call.
The access or deaccess code cannot be more
than 10 characters.
Making a Private Call with a One Touch Call Button
Note: Programmable buttons press must be initiated
from the Home screen.
The One Touch Call feature allows you to easily
make a Private Call to a pre-defined Private Call alias
Making and Receiving Calls in Non-Connect Plus Mode
47
English