User's Guide

• Press One Touch Access button. The DTMF
tone sounds. If the entry for the One Touch
Access button is empty, a negative indicator
tone sounds.
5
Press to end the call. If deaccess code was
not preconfigured in the Contacts list, the first line
of the display shows De-Access Code: . The
second line of the display shows a blinking cursor.
Enter the deaccess code and press
to
proceed. The radio returns to the previous screen.
The DTMF tone sounds and the display shows
Ending Phone Call.
If successful, a tone sounds and the display shows
Phone Call Ended. Your radio returns to the
screen you were on prior to initiating the call.
If unsuccessful, your radio returns to the Phone
Call screen. Repeat the Step 5 on page 139 or
wait for the telephone user to end the call.
When you press the PTT button while in the
Phone Contacts screen, as tone sounds and the
display shows Press OK to Place Phone Call.
When the telephone user ends the call, a tone
sounds and the display shows Phone Call
Ended.
If the call ends while you are entering the extra
digits requested by the Phone Call, your radio
returns to the screen you were on prior to initiating
the call.
Note:
During the channel access, press to dismiss
the call attempt and a tone sounds.
During the call, when you press One Touch
Access button with the deaccess code
preconfigured or enter the deaccess code as the
input for extra digits, your radio attempts to end
the call.
During channel access and access/deaccess code
or extra digits transmission, you radio responds to
On/Off button, Volume Knob, and Channel
Rocker only. A tone sounds for every invalid input.
The access or deaccess code cannot be more
than 10 characters.
Keypad Microphone Features
139
English