User's Guide

The DTMF tone sounds and the display shows
Ending Phone Call.
If successful, a tone sounds and the display shows
Call Ended. Your radio returns to the Phone Call
screen.
If unsuccessful, your radio returns to the Phone
Call screen. Repeat the step above or wait for the
telephone user to end the call.
Note:
When you press PTT button while in the Phone
Contacts screen, a tone sounds and the display
shows Press OK to Place Phone Call.
When the telephone user ends the call, a tone
sounds and the display shows Call Ended.
If the call ends while you are entering the extra
digits requested by the Phone Call, your radio
returns to the screen you were on prior to initiating
the call.
During the channel access, press to dismiss
the call attempt and a tone sounds.
During the call, when you press One Touch
Access button with the deaccess code
preconfigured or enter the deaccess code as the
input for extra digits, your radio attempts to end
the call.
During channel access and access/deaccess code
or extra digits transmission, you radio responds to
On/Off button, Volume Knob, and Channel
Rocker only. A tone sounds for every invalid input.
The access or deaccess code cannot be more
than 10 characters.
Making a Phone Call with the One Touch Access
Button
1 Press the programmed One Touch Access
button to make a Phone Call to the predefined
alias or ID.
If the entry for the One Touch Access button is
empty, a negative indicator tone sounds.
2 If the access code was not preconfigured in the
Contacts list, the first line of the display shows
Access Code:. The second line of the display
shows a blinking cursor. Enter the access code
and
to proceed.
Keypad Microphone Features
135
English