User's Manual

iO1500R Evaluation board
The evaluation board helps the developer and system integrator to start development
of the software before their terminal hardware is ready. The developer can connect a
PC to the evaluation board and communicate with the iO1500R that is registered to
the system and work over the iDEN infrastructure. For more information see the OEM
Evaluation Board User Guide 68P02954C85-O.
Safety Notice - ATTENTION
This iDEN iO1500R Module is restricted to occupational use only to satisfy
FCC RF energy exposure requirements. Before using this product, read the RF energy
awareness information and operating instructions in the Product Safety and RF
Exposure booklet (Motorola Publication part number 6881095C99) to ensure
compliance with RF energy exposure limits.
FCC Regulation - Letter of Notice
As you know, the iO1500R RF module that we are supplying to you for incorporation
into Final Products are components that, when connected to the power supply, internal
signaling, and antenna in a Final Product can receive and transmit module signals.
In the United States, the Federal Communications Commission requires that many
module transmitting devices obtain approval before being offered on the market,
unless the device is exempt. While the iO1500R has been designed to meet applicable
FCC requirements, provided in the code of Federal Regulation 47CFR part II subpart
J and 47CFR part 90 subpart S, the Final Product's compliance with the FCC's
requirements, including RF energy exposure requirements, must reflect product usage,
positioning of the iO1500R within the product, the type of antenna used, the location
of the antenna, and other factors that may vary with the design and nature of the Final
Product. Therefore, compliance with such FCC requirements can only be determined
by an assessment of the Final Product.
It is important that any manufacturer to whom you resell the iO1500R for use in a
final product also recognize that they will have the responsibility for taking all
necessary steps to ensure that the Final Product meets any applicable FCC
requirements and for obtaining any necessary approval from the FCC for sale and
operation of the Final Product. To the extent that this may require testing and
assessment of the Final Product, this will be the responsibility of the manufacturer.
To the extent that this may require development of user information or guidance to be
provided to each purchaser of the Final Product, this will also be the responsibility of
the manufacturer.
Information covering the FCC tests that are required is located in Appendix A.
Please provide a copy of this reminder to every manufacturer to whom you resell these products.
20/5/03 page 7 of 37