User's Manual
Table Of Contents
- Application and Integration
- Developers Guide
- DECLARATION OF CONFORMITY
- DECLARATION OF CONFORMITY2Revision History5Purpose Of This Document5Distribution5Related Documentation5Module Descriptions and Specifications6iO15 Modem Product Specificationss6Electrical specifications:6Environmental Specifications6Other Specifications
- Purpose Of This Document
- Distribution
- Related Documentation
- Module Descriptions and Specifications
- iO1500R Evaluation board
- Safety Notice - ATTENTION
- iO1500R Hardware Interfacing Information
- Design Considerations For iO1500R OEM Developers
- Module Software And Interface Modes
- Managing User Image Profiles
- How To Use Hayes Compatible Packet Data mode
- iDEN data modules – Software integration.
- Additional Information For Registering and Going Offline
- Summary Of AT Commands
- Appendix A: Requirements For FCC Testing
Summary Of AT Commands
This is a consolidated list of the AT commands mentioned in this document.
See the iDEN Mobile Subscriber DTE/DCE Interface for Data Services
68P81129E10-C for detailed AT command descriptions.
General AT Commands
Command Usage Remarks
AT AT Checks communication.
ATEx ATE0 or ATE1 Sets echo on or off.
AT&V AT&V Displays module parameters.
AT+IPR AT+IPR= baud rate Sets the baud rate of the module
User Image Profile Management Commands
Command Usage Remarks
ATz ATz0, ATz1, or ATz2 Sets the specified image as the active image.
AT&Wx AT&W0, 1, or 2. Writes active image to the specified profile.
Hayes Compatible Packet Data Commands
Command Usage Remarks
AT+ws45 AT+ws45=0 or 3 or 4 Selects the DTE side protocol stack.
AT+ws46 AT+ws45=23 or 24 Selects the carrier/network side stack.
ATd ATd <IP_address>..<port#> Tells module to originate a call.
Registration, Reset, and power off Commands
Command Usage Remarks
AT+wvreset AT+wvreset Resets the iO15 modem.
AT+wvmr AT+wvmr=”xxxx” (0000) Master Resets the iO15 modem.
AT+wvpo At+wvpo Software Powers Off the iO15 modem.
AT+WPDEREG AT+WPDEREG Forces modem to deregister.
AT+WPREG AT+WPREG Forces modem to register
AT+trace AT+trace Service Status Log
SIM card management Commands
Command Usage Remarks
AT+wvsim +wvsim=”<SIM PIN>” Unlocks the SIM card.
AT+wvsim +wvsim? Query SIM status.
AT+wvsim +wvsim=? Range.
AT+wvsimtgl +wvsimtgl=1,”<SIM PIN>” Enables SIM PIN mechanism
AT+wvsimtgl +wvsimtgl=0,”<SIM PIN>” Disables SIM PIN mechanism
AT+wvsimtgl +wvsimtgl? Query SIM PIN mechanism status.
AT+wvsimtgl +wvsimtgl=? Range.
20/5/03 page 28 of 37