User's Manual
Table Of Contents
- Application and Integration
- Developers Guide
- DECLARATION OF CONFORMITY
- DECLARATION OF CONFORMITY2Revision History5Purpose Of This Document5Distribution5Related Documentation5Module Descriptions and Specifications6iO15 Modem Product Specificationss6Electrical specifications:6Environmental Specifications6Other Specifications
- Purpose Of This Document
- Distribution
- Related Documentation
- Module Descriptions and Specifications
- iO1500R Evaluation board
- Safety Notice - ATTENTION
- iO1500R Hardware Interfacing Information
- Design Considerations For iO1500R OEM Developers
- Module Software And Interface Modes
- Managing User Image Profiles
- How To Use Hayes Compatible Packet Data mode
- iDEN data modules – Software integration.
- Additional Information For Registering and Going Offline
- Summary Of AT Commands
- Appendix A: Requirements For FCC Testing
Packet Data Status Information Command
To check the current state of the iO1500R, use the Packet Data Status Information
command. This is the AT command to be used:
AT+wpstate
Below is what the iO1500R might respond with when this command is used:
AT+wptrace
Below is what the iO1500R might respond with when this command is used:
20/5/03 page 26 of 37