User's Manual
Table Of Contents
- Application and Integration
- Developers Guide
- DECLARATION OF CONFORMITY
- DECLARATION OF CONFORMITY2Revision History5Purpose Of This Document5Distribution5Related Documentation5Module Descriptions and Specifications6iO15 Modem Product Specificationss6Electrical specifications:6Environmental Specifications6Other Specifications
- Purpose Of This Document
- Distribution
- Related Documentation
- Module Descriptions and Specifications
- iO1500R Evaluation board
- Safety Notice - ATTENTION
- iO1500R Hardware Interfacing Information
- Design Considerations For iO1500R OEM Developers
- Module Software And Interface Modes
- Managing User Image Profiles
- How To Use Hayes Compatible Packet Data mode
- iDEN data modules – Software integration.
- Additional Information For Registering and Going Offline
- Summary Of AT Commands
- Appendix A: Requirements For FCC Testing
If Signal Quality is not good, wait in the loop, checking signal quality every 10 sec,
until a usable value is measured.
If the iDEN data module is not Mobile IP registered wait for 1 minute, checking MIP
registration status every 10 seconds. If after one minute the iDEN data module is not
MIP registered, a new registration needs to be forced. Use AT-commands to force the
module de-registration and re-registration:
Force deregistration AT+WPDEREG
Force registration AT+WPREG
Go back to Step 3) again.
4) Wait for at least 2 seconds and make the PPP/SLIP connection
ATZ2 Go to profile 2.
ATD Start PPP/SLIP connection, according to the AT+WS45 setup.
5) During the PPP/SLIP connection check network status periodically.
Check Signal Quality with this AT command: AT+WS53?
If Signal Quality is not good, wait in the loop, checking signal quality every 10 sec,
until a usable value is measured.
If iDEN data module is not Mobile IP registered wait for 1 minute, checking MIP
registration status every 10 seconds. If after one minute the iDEN data module is not
MIP registered, a new registration needs to be forced. Drop PPP/SLIP connection.
Use AT-commands to force iDEN data module de-register and re-register again.
Force deregistration AT+WPDEREG
Force registration AT+WPREG
Go back to Step 3)
20/5/03 page 24 of 37