User's Manual
Table Of Contents
- Application and Integration
- Developers Guide
- DECLARATION OF CONFORMITY
- DECLARATION OF CONFORMITY2Revision History5Purpose Of This Document5Distribution5Related Documentation5Module Descriptions and Specifications6iO15 Modem Product Specificationss6Electrical specifications:6Environmental Specifications6Other Specifications
- Purpose Of This Document
- Distribution
- Related Documentation
- Module Descriptions and Specifications
- iO1500R Evaluation board
- Safety Notice - ATTENTION
- iO1500R Hardware Interfacing Information
- Design Considerations For iO1500R OEM Developers
- Module Software And Interface Modes
- Managing User Image Profiles
- How To Use Hayes Compatible Packet Data mode
- iDEN data modules – Software integration.
- Additional Information For Registering and Going Offline
- Summary Of AT Commands
- Appendix A: Requirements For FCC Testing
SSL Command response
The SSL AT command response will have the following syntax:
DISPATCH [IS,NS (2 bytes)] [ACPT, RJCT, N_AT (4 bytes)] [RNC (6 bytes)] [0-4
cause codes, 2 bytes each, separated by comma]
INTERCONNECT [IS,NS (2 bytes)] [ACPT, RJCT, N_AT (4 bytes)] [RNC (6
bytes)] [0-4 cause codes, 2 bytes each, separated by comma]
PACKET DATA [IS,NS (2 bytes)] [ACPT, RJCT, N_AT (4 bytes)][RNC (6 bytes)]
[0-4 cause codes, 2 bytes each, separated by comma]
MOBILE IP [IS,NS (2 bytes)] [ACPT, RJCT, N_AT (4 bytes)][RNC (6 bytes)] [0-4
cause codes, 2 bytes each, separated by comma]
PHONE RST [IS,NS (2 bytes)] [RSTR, N_AT (4 bytes)] [RNC 6 bytes] [0-4 cause
codes, 2 bytes each, separated by comma]
Each SSL entry is presented in one line.
The [ ] signs indicate a field with possible values and length.
PC Applications To Control the iO1500R
FVN4780A - iDEN module - Packet Data Applet
This program can be used with the iO1500R sitting on the Evaluation Board. See the
iM1000 Data Module User's Guide - 68P02953C65-A for detailed description about
how to install and use this program. The complete application is composed of three
software modules: Status Program, Configuration Program and Service Program.
Status Program
The Status Program window is a Windows only program that is part of the module
applet, and provides an enhanced method of starting a PPP or SLIP connection to the
module. It also provides some helpful information about the DCE (iO1500R OEM
Module) and Packet Data communication. For example the program can display
RSSI, Kbytes sent/received and more.
Configuration Program
The Configuration Program provides a method for configuring and displaying
networking parameters (Primary and secondary DNS, Server IP address, etc.) and
modem parameters for packet data services. It provides a method for customizing user
settings (for example: Master Reset, SIM PIN change/unblock/enable/disable, etc.)
and allows the user to define the default data service.
Service Program
The Service Program is a GUI that provides service technicians a method to perform
field-testing for an iO15 modem.
20/5/03 page 22 of 37