User's Manual
Table Of Contents
- Application and Integration
- Developers Guide
- DECLARATION OF CONFORMITY
- DECLARATION OF CONFORMITY2Revision History5Purpose Of This Document5Distribution5Related Documentation5Module Descriptions and Specifications6iO15 Modem Product Specificationss6Electrical specifications:6Environmental Specifications6Other Specifications
- Purpose Of This Document
- Distribution
- Related Documentation
- Module Descriptions and Specifications
- iO1500R Evaluation board
- Safety Notice - ATTENTION
- iO1500R Hardware Interfacing Information
- Design Considerations For iO1500R OEM Developers
- Module Software And Interface Modes
- Managing User Image Profiles
- How To Use Hayes Compatible Packet Data mode
- iDEN data modules – Software integration.
- Additional Information For Registering and Going Offline
- Summary Of AT Commands
- Appendix A: Requirements For FCC Testing
DECLARATION OF CONFORMITY
Per FCC CFR 47 part 2 Section 2.1077(a)
Hereby declares that the product:
Conforms to the following regulation:
FCC Part 15, subpart B
Class B Computer Peripheral Device
Date: MAY 15, 2003
Responsible party name: Motorola Inc.
Address: 8000 West Sunrise Boulevard,
Plantation, FL 33322 USA
Phone number: 1
(
800
)
453-0920
Product name: iO1500R
Model Number: F2572A
FCC ID:
A
Z492FT5826
N
ote: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
20/5/03 page 2 of 37