User's Manual

56
Trunking Operation
Edit a Name in the List
(W7 and W9 Control Heads Only)
1 Press and hold the Phon button to enter Phon ID list
programming.
The Phon indicator flashes and a high-pitched tone sounds.
2 Press the Mode rocker button to locate the list member you
want to change.
3 Change the characters or numbers using any of the numeric
keys (0 through 9) and special function keys
(*, #).
Note: The maximum number of characters permitted in a text line
is 8 for W7 Control Head and 11 for W9 Control Head. If you
try to add too many characters, you will hear a low-pitched
tone.
To edit, do any or all of the following:
• To enter a character at the blinking cursor, refer to the table
on page 57.
Press the key of the desired character the number of times
shown in the table. For example, to enter the character C,
press the 2 key three times.
• To leave a space in the text, press the Mode up
 rocker
button to move the blinking cursor to the next character
position, and then enter the character.
• To delete characters, press the Mode down
 rocker button
to move backwards over existing characters.
When the last character on the display has been erased,
press the Mode down
 rocker button again to leave the
name-edit mode, without making any changes, and begin
the procedure again at step 2.
4 To save the changes, press and hold the Sel button.