User's Manual
Table Of Contents
- ASTRO® XTL™ 5000 Mobile Radio with W4, W5, W7, and W9 Control Heads User's Guide
- Front Cover
- W4 Quick Reference Card
- W5 Quick Reference Card
- Control Head Front Foldout
- Inside Title Page
- Contents
- Introduction
- Basic Operating Procedures
- General Radio Features
- Often-used Features
- Emergency Call and Alarm
- Scan Operation
- Turn On Scan
- Turn Scan On While Disregarding the Squelch Code (Conventional Modes Only)
- View a Scan List
- Transmit While Scan Is On
- Temporarily Delete a Nuisance Mode With Scan On (W7 and W9 Control Heads Only)
- Restore a Nuisance Mode (W7 and W9 Control Heads Only)
- Change Mode Priorities While Scan Is On (W7 and W9 Control Heads Only)
- Restore Mode Priorities in a Scan List (W7 and W9 Control Heads Only)
- Program a Scan List
- Hang Up Box (HUB)
- Optional External Alarms (Horn and Lights)
- Time-Out Timer
- Push-To-Talk Identification (PTT-ID)
- Conventional Radio Features
- Trunking Operation
- Features Used on Trunking Systems
- Telephone Interconnect List
- Unlimited Telephone Interconnect (W7 and W9 Control Heads Only)
- Enhanced Private Conversation (Digital Modes Only)
- Call Alert Page (Digital Modes Only)
- Failsoft
- Dynamic Regrouping (Digital Modes Only)
- SmartZone® (W7 and W9 Control Heads Only)
- Out-of-Range Indication
- Trunked Announcement
- Secure Operation
- Troubleshooting
- Glossary
- Index
- Control Head Back Foldout
- W7 Quick Reference Card
- W9 Quick Reference Card
- Back Cover
92
Troubleshooting
Troubleshooting
The following are suggestions to assist you in troubleshooting
possible operating problems.
If your radio is locked up or the display shows
FL 01/90 (W4, W5,
W7) or
FAIL 01/90 (W9), turn the radio off and then back on. If this
does not correct the condition, take the radio to a qualified radio
technician for service.
If radio operation is intermittent, check with other persons using the
system for similar problems before taking the radio in for service.
Similar problems indicate a system malfunction rather than a radio
failure.
If symptoms persist or, if your unit exhibits other problems, contact a
qualified radio technician.
The cables that connect to the rear of
the radio could have live voltage on
some of their pins. Do not remove or
reconnect these cables. Only a
qualified radio technician should
perform this task. Service performed
by unauthorized personnel may cause
the radio to transmit an emergency
alarm even if the unit is turned off.
CAUTION
!