User's Manual
Table Of Contents
- Contents
- Computer Software Copyrights
- Radio Frequency (RF) Exposure Safety Standards
- FCC Licensing Information
- Introduction
- Repeater Overview
- Pre-Installation Considerations
- Repeater Installation
- Alkaline Battery Frame
- Getting Started
- Programming The Repeater
- Programming Your Radios
- Repeater Cloning
- Troubleshooting
- Use and Care
- Motorola Limited Warranty for the United States and Canada
- Accessories
- Appendix A: Repeater Specifications
APPENDIX A: REPEATER
SPECIFICATIONS
68
User Guide
Dust 510.4 1
Vibration 514.5 1
Shock 516.5 1
Environmental Specifications
Operating Temperature -30°C to + 60°C (Radio) -30°C to + 60°C (Radio)
Sealing
(2)
IP55 IP55
Shock & Vibration Polycarbonate Housing passes EIA 603
Dust & Humidity
(3)
Satisfied EIA 603
(1)
MIL STD 810 C, D, E, and F, have blowing rain of sections that call out the device shall survive subjection to 30
minutes of a 4 inch/hour in a 40 mph wind. Dust section calls out blowing dust around 11ug/m3 for 6 hours.
(2)
IP55 means the enclosure is dust protected. It also means it is water protected as if jet of water were sprayed
by a hose ( 3 gal/min for at least 3 minutes).
(3)
Relative Humidity (RH) is 95% at a -30°C to 60°C.
810 Military Standards
(1)
RPX Repeater 4 W –UHF 450 – 470 MHz
METHOD PROCEDURE