User's Manual
Table Of Contents
- Contents
- Computer Software Copyrights
- Radio Frequency (RF) Exposure Safety Standards
- FCC Licensing Information
- Introduction
- Repeater Overview
- Pre-Installation Considerations
- Repeater Installation
- Alkaline Battery Frame
- Getting Started
- Programming The Repeater
- Programming Your Radios
- Repeater Cloning
- Troubleshooting
- Use and Care
- Motorola Limited Warranty for the United States and Canada
- Accessories
- Appendix A: Repeater Specifications
PROGRAMMING THE
REPEATER
40
User Guide
Programming the Repeater Using the
CPS
Before you begin programming the repeater make
sure you have available:
• A PC ( Windows® XP, Windows 2000 compatible,
Vista)
• CPS Programming Cable (sold separately as an
accessory P/N RKN4155),
• CPS* Software installed
• Repeater batteries are charged or repeater is
connected to a AC/DC power line.
Please notice that this CPS
Programming cable’s mini-
connector should not be used for
connecting devices other than the
RDX Series chargers (RLN6304/
RLN6375) and the repeaters.
RP
X
CPS
So
f
tware
To computer
USB Port
To repeater
programming
connector
CPS Programming
Cable
Figure 18. Programming the Repeater
U
sing the CPS
Important