User's Manual
Table Of Contents
- Contents
- Computer Software Copyrights
- Radio Frequency (RF) Exposure Safety Standards
- FCC Licensing Information
- Introduction
- Repeater Overview
- Pre-Installation Considerations
- Repeater Installation
- Alkaline Battery Frame
- Getting Started
- Programming The Repeater
- Programming Your Radios
- Repeater Cloning
- Troubleshooting
- Use and Care
- Motorola Limited Warranty for the United States and Canada
- Accessories
- Appendix A: Repeater Specifications
26
REPEATER
INSTALLATION
Installation Guide
To install the wall mount:
1. The wall mount holster is designed to be
capable of mounting to a wall or any other
similar flat surface via screws, straps or
single bolt. (If you choose to use screws,
make sure you secure them tightly on each
one of the wall mount corners).
2. Once the wall mount is firmly secured to a
surface, slide the repeater device from top to
bottom of the holster (“Figure 14b. Installing
the Wall Mount Holster” on page 26) until the
repeater clicks in place into the wall mount
rails.
3. Proceed to connect antenna and power
supply cables.
Remember not to install the repeater on
or near conductive or shielding
surfaces.
Important
Figure 14b. Installing the Wall Mount Holster