User's Manual
Table Of Contents
- Contents
- Computer Software Copyrights
- Radio Frequency (RF) Exposure Safety Standards
- FCC Licensing Information
- Introduction
- Repeater Overview
- Pre-Installation Considerations
- Repeater Installation
- Alkaline Battery Frame
- Getting Started
- Programming The Repeater
- Programming Your Radios
- Repeater Cloning
- Troubleshooting
- Use and Care
- Motorola Limited Warranty for the United States and Canada
- Accessories
- Appendix A: Repeater Specifications
20
REPEATER
INSTALLATION
Installation Guide
Antenna Installation Instructions
Repeater antenna installation is critical to the
system performance. The approved Motorola
antenna for the RPU4160 is the UHF Dipole
Antenna P/N HKAE4000, (50 Ohm).
Attaching the Dipole Antenna to
the Repeater
(Installing the dipole antenna directly onto the
repeater is recommended whenever coverage
range or obstructions are not an issue or/and the
repeater is likely to be moved around to other
sites).
1. Align the threaded end of the antenna with
the repeater’s antenna connector and turn
the antenna bushing clockwise to fasten it.
“Figure 9. Attaching Dipole Antenna to the
Repeater (clockwise)” on page 20.
Figure 9. Attaching Dipole Antenna to the
Repeater (clockwise)