User's Manual
Table Of Contents
- Contents
- Computer Software Copyrights
- Radio Frequency (RF) Exposure Safety Standards
- FCC Licensing Information
- Introduction
- Repeater Overview
- Pre-Installation Considerations
- Repeater Installation
- Alkaline Battery Frame
- Getting Started
- Programming The Repeater
- Programming Your Radios
- Repeater Cloning
- Troubleshooting
- Use and Care
- Motorola Limited Warranty for the United States and Canada
- Accessories
- Appendix A: Repeater Specifications
7
REPEATER OVERVIEW
.
Note: (1) The repeaters work best when located in
an ideal place that can have good reception
for re-transmitting the signal without any
problems. Refer to "Pre-Installation
Considerations” on page 10 for more
information.
(2) The repeaters are not submersible
devices (Refer to "Appendix A: Repeater
Specifications” on page 61 for more
information) and it is NOT an FM (Factory
Mutual) certified device.
(3) Out of the 16 pre-programmed channels
that are available out of the box, you can
select only ONE channel each time you TX/
RX with the repeater. The repeaters are NOT
multi-channel repeaters.
(4) The repeaters’ CPS software is required.
Refer to "Programming The Repeater” on
page 38 for more information.
Figure 2a. Repeater Application Example –
Indoors
Figure 2b. Repeater Application Example –
Outdoors