User's Manual
Table Of Contents
- ASTRO® XTL™ 5000 Mobile Radio with W4, W5, W7, and W9 Control Heads User's Guide
- Front Cover
- W4 Quick Reference Card
- W5 Quick Reference Card
- W4 and W5 Control Heads Foldout Page
- Inside Title Page
- Product Safety and RF Exposure Compliance
- Computer Software Copyrights
- Documentation Copyrights
- Disclaimer
- Notations Used in this Manual
- Contents
- Introduction
- Basic Operating Procedures
- General Radio Features
- Often-used Features
- Emergency Call and Alarm
- Scan Operation
- Turning On Scan
- Turning Scan On While Disregarding the Squelch Code (Conventional Modes Only)
- Viewing a Scan List
- Transmitting While Scan Is On
- Temporarily Deleting a Nuisance Mode With Scan On (W7 and W9 Control Heads Only)
- Restoring a Nuisance Mode (W7 and W9 Control Heads Only)
- Changing Mode Priorities While Scan Is On (W7 and W9 Control Heads Only)
- Restoring Mode Priorities in a Scan List (W7 and W9 Control Heads Only)
- Programming a Scan List
- Hang Up Box (HUB)
- Optional External Alarms (Horn and Lights)
- Time-Out Timer
- Push-To-Talk Identification (PTT-ID)
- Telephone Interconnect List (Conventional and Trunking)
- Unlimited Telephone Interconnect (W7 and W9 Control Heads Only)
- Call Alert Page (Conventional and Trunking— Digital Modes Only)
- Conventional Radio Features
- Trunking Operation
- Secure Operation
- Troubleshooting
- Glossary
- Index
- W7 and W9 Control Heads Foldout Page
- W7 Quick Reference Card
- W9 Quick Reference Card
- Back Cover
70
Conventional Radio Features
Storing a Unit ID Number in the List
(W7 and W9 Control Heads Only)
The Selective and Call Alert page features share the same prestored
list of units’ IDs.
1 Press and hold , , or to review
the Call ID list.
The Call indicator flashes and a high-pitched tone sounds.
2 Press the Mode rocker switch to locate the list member you
want to change.
3 Press to select the unit ID store function.
4 Enter the new unit ID number on the keypad.
Note: If you make an error, press the Mode down
rocker switch
or #Del to erase each incorrect digit.
5 When all the digits of the ID are entered, press to
store the new ID.
6 Repeat steps 2 through 5 until all the desired IDs have been
entered.
OR
Do one of the following:
• Press the to return to normal radio operation.
OR
• Press to return to normal Call operation.
Call
Page 2Pge
Sel
Sel
HOME
Call