User's Manual
Table Of Contents
- ASTRO® XTL™ 5000 Mobile Radio with W4, W5, W7, and W9 Control Heads User's Guide
- Front Cover
- W4 Quick Reference Card
- W5 Quick Reference Card
- W4 and W5 Control Heads Foldout Page
- Inside Title Page
- Product Safety and RF Exposure Compliance
- Computer Software Copyrights
- Documentation Copyrights
- Disclaimer
- Notations Used in this Manual
- Contents
- Introduction
- Basic Operating Procedures
- General Radio Features
- Often-used Features
- Emergency Call and Alarm
- Scan Operation
- Turning On Scan
- Turning Scan On While Disregarding the Squelch Code (Conventional Modes Only)
- Viewing a Scan List
- Transmitting While Scan Is On
- Temporarily Deleting a Nuisance Mode With Scan On (W7 and W9 Control Heads Only)
- Restoring a Nuisance Mode (W7 and W9 Control Heads Only)
- Changing Mode Priorities While Scan Is On (W7 and W9 Control Heads Only)
- Restoring Mode Priorities in a Scan List (W7 and W9 Control Heads Only)
- Programming a Scan List
- Hang Up Box (HUB)
- Optional External Alarms (Horn and Lights)
- Time-Out Timer
- Push-To-Talk Identification (PTT-ID)
- Telephone Interconnect List (Conventional and Trunking)
- Unlimited Telephone Interconnect (W7 and W9 Control Heads Only)
- Call Alert Page (Conventional and Trunking— Digital Modes Only)
- Conventional Radio Features
- Trunking Operation
- Secure Operation
- Troubleshooting
- Glossary
- Index
- W7 and W9 Control Heads Foldout Page
- W7 Quick Reference Card
- W9 Quick Reference Card
- Back Cover
ASTRO XTL 5000 Digital Mobile Radio with W4, W5, W7, and W9 13
Basic Operating Procedures
Selecting or Changing a Mode in the Current Zone
Selecting or Changing to a Mode Not in the Current
Zone
To access a mode in the current zone, do one of the following:
• W4 Control Head: Turn the Mode knob until the display
shows the desired mode name.
• W5 Control Head: Press the Mode rocker switch until the
display shows the desired mode name.
• W7 and W9 Control Heads:
1 Press and hold .The zone/mode flashes.
2 Release .
3 Enter the number by the keypad, and press
again.
1 To access a mode that is not in the current zone, press the
Zone up
button or Zone down button to move to the zone
containing the mode.
Note: The Zone up
and Zone down buttons are optional
buttons included with the radio when zone/mode is ordered.
2 Do one of the following:
• W4 Control Head: Turn the Mode knob to select the desired
mode.
• W5, W7, and W9 Control Heads: Press the Mode rocker
switch to select the desired mode.
HOME
HOME
HOME