Installation Instructions

6881098C38-O September 30, 2004
Standard Configurations: Power Cable 2-19
2.2.3 Locking Kit (Optional)
2.2.3.1 All Radios Except 100W
If an optional locking kit is used (shown in
Figure 2-26), position the lock bottom housing on the
trunnion before installing the radio mounting screws. Then slip the top lock housing on and remove
the key. You can install the lock on either side of the radio, and by rotating it 180°, you can also install
it on dash installations.
Figure 2-26. Locking Kit (Optional) (Cannot Be Used for 100W Radios)
2.2.3.2 100W Radios
An integral lock is included in the quick release trunnion (HLN6909_). The use of this lock is required
for proper operation (see
Figure 2-27).
Figure 2-27. Lock Supplied with 100W Quick Release Trunnion
2.3 Power Cable
Route the red radio power cable from the radio to the vehicle’s battery compartment, using accepted
industry methods and standards. Be sure to grommet the firewall hole to protect the cable. Remove
the 15-amp (part number 6580283E06), 20-amp (part number 6580283E07) or 30-amp (for 100W)
fuse from the fuseholder and connect the red lead of the radio power cable to the positive battery
terminal using the hardware provided as shown in
Figure 2-28 and Figure 2-29. Connect the black
lead to a convenient solid chassis ground point. DO NOT connect the black lead directly to the
battery’s negative terminal.
Existing
Mounting
Screw
Lock
Lock
Housing
HLN6372_ Locking Kit